Due to the changes in the law concerning the use of poison to combat weeds, Kemp has developed a weed brush. This weed brush removes weeds in an environmentally friendly manner and is therefore a good replacement for the poison. The weed brushes from Kemp are hydraulically driven, due to this rotating movement the weeds are loosened.
The weed brush is designed with a oscillating construction, so that the brush is ground-following, therefore it is not necessary to correct the height for irregularities of +/- 15 cm. At the same time, the angle of the brush can be adjusted by lifting the frame or lowering it for a more or less aggressive effect.
This weed brush can be connected to (mini) loaders, (mini) excavator, tractor, forklift etcetera, as long as the minimum oil yield is 25 liters. The OKB has one brush.
The weed brush is available as a fixed or hydraulically pivoting version. In the fixed version, the brush can be placed from out the middle of the vehicle, so that the brush is still besides the vehicle.
The weed brush is available with the attachments that belong to your vehicle (for the attachment parts, see the document: Kemp attachment parts).
For additional specifications, see the document: product specifications.
Tilting 15 degrees: A new option has been designed for a 3-point and forklift truck attachment. The option allows the machine to tilt the brush 15 degrees. Both front and back the brush can be adjusted by 15 degrees. The advantage here is that the brush can be used more aggressively by tilting.
Tilting the weed brush 15 degrees can be operated both mechanically and hydraulically.
Rubber flap: The rubber flap ensures that the weeds do not fly far away. The rubber flap can be adjusted in several positions.
Removable attachment parts: It is possible to order the attachments not welded but mounted with bolts and nuts. This allows you to easily replace the attachments when necessary.
Non-pressurized return connection: If you expect to use the weed brush intensively, it is our advice to place this option.
Overpressure / after-turn valve: At an operating pressure above 225 bar, an overpressure must be installed to prevent overload.
The after-turn valve is to relieve the hydromotor when suddenly stopping or changing the direction of rotation of the brush.