en
Back

Heavy, fixed rubber scraper (RSVK)

Kemp's fixed sliders are suitable for moving food residues, mud, manure, snow, recycling waste, chips and similar. The corners of the fixed sliders are placed in a 30 degree angle, this allows the dirt to be moved well.

The fixed slides can be supplied with attachment parts for (mini) loaders, tractors, telehandlers, forklift trucks, etc. (for the attachments, see the document: Kemp attachment parts).

Description

The RSVK is the heaviest version of the fixed scraper available at Kemp. Thus, this scraper is suitable for intensive sliding and can be used as an attachment on heavy vehicles. The RSVK differs from the normal RSV due the fact that it is equipped with a hollow steel profile instead of an UNP profile. In addition, heavier tubes are used for the frame.

The RSVK is available with a forklift receiver or equipped with attachment parts. In the variants where attachment parts are welded on, a rubber support base has been used, so the slide is always straight and can be connected quickly. Coupling is also simple with a forklift receiver.

The forklift receiver version is completely galvanized. The zinc layer protects the scraper well against the effects of weather and dirt. The version with attachment parts is lacquered; The scraper is treated with a high-quality 2-component anti-corrosion primer, and finished with a 2 component polyurethane high-gloss coating. Advantages of this coating are the adhesion and the impact resistance, in addition, the outdoor durability is very good due to the high gloss retention and colour fastness. It is possible, as an option, to also order this version completely galvanized.

The RSVK is available in two types, namely the RSVK140 and the RSVK180. The number behind RSVK refers to the type of the hollow steel profile that is used. With the RSVK140 a 140 mm profile is used and with the RSVK180 a 180 mm profile.

The RSVK140 is available in the sizes 1,400, 1,800, 2,200 and 2,500 mm and the RSVK180 in sizes 2,500, 2,700, 3,000 and 3,200. For the RSVK140 series the rubbers are 400 mm high and for the RSVK180 2.700, 3.000 and 3.200 you can choose a 500 mm high rubber. In this higher rubber two rows of holes are drilled, allowing you to turn over or lower the rubber when one side is worn.

Options:

Forklift receiver + possibility for build on parts: As a standard version you can choose for forklift or attachments. However, it is also possible to integrate both on one scraper.

It is possible to galvanize the variant with attachment parts completely. This makes the scraper even less sensitive to weather influences.

Close